GRAPHTEC CE7000-130 - Page 225

CE7000-UM-251-9370 22
9 TROUBLESHOOTING
Error
code
Error Display Cause Solution
E04005
When this error was displayed
while scanning the horizontal
line of 2nd registration mark.
The media is tilting to the right
when the media was loaded.
Load the media straightly.
Use the large registration mark
when it is small registration mark.
When this error was displayed
while scanning the horizontal
line of 2nd registration mark.
There is printing object around
the 2nd registration mark.
Do not print any printing object
around the 2nd registration mark.
When this error was displayed
while scanning the horizontal
line of 2nd registration mark.
The media is skewing while
feeding the media.
Use the media of strong adhesive
strength.
When this error was displayed
while scanning the horizontal
line of 2nd registration mark
when sheet media was loaded
with the ROLL 1 or ROLL 2.
The 2nd registration mark is
not printed in the scanning area
(The 6 mm inside from cutting
area).
Print the 2nd registration mark to the
6 mm inside from the scanning area
(Cutting area).
There is not enough margin from
the horizontal line of 2nd registration
mark to the rear of media edge.
Load the media with the SHEET,
and then conrm it is able to feed
to 6 mm outside from the horizontal
line of 2nd registration mark.
When this error was displayed
while scanning the vertical line
of 3rd registration mark.
The media is skewing while
feeding the media.
Use the media of strong adhesive
strength.
When this error was displayed
while scanning the vertical line
of 3rd registration mark.
There is printing object around
the 3rd registration mark.
Do not print any printing object
around the 3rd registration mark.