2 – 10 CS500/IS200
2. PREPARATION
2.3 Attaching the Document Support Wires
Always ensure that the document support wires are attached to the scanner unit before
scanning a document.
Note: Drawings of the CS500 model are used for the explanations.
Document
support wires
The document may be damaged upon contact with the power cable if it is scanned
without the document support wires in place.
Attaching the document support wires
(1) Insert one end of the document support wire provided into one of the smaller slots
at the rear of the scanner.
There is a second, hidden slot directly underneath each slot. Insert the end of the wire
so that it fits into the hidden slot on the lower level.
Hidden slot on the lower level
Document support wire end
To Next Page
Loading...
