EasyManua.ls Logo

GRAPHTEC CS500 - Removing a Jammed Document

GRAPHTEC CS500
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 – 6 CS500/IS200
5. DAILY MAINTENANCE
5.5 Removing a Jammed Document
If a document becomes jammed in the scanner during scanning or another operation,
immediately turn off the scanner, remove the document hold-down unit, and then remove
the jammed document.
Procedure
(1) Turn off the scanner.
(2) Open the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
(3) If the document is jammed at the front, remove the document from the inside or by
pulling it forward.
The above illustration is of the CS500 model.
(4) If the document is jammed at the rear, remove the document from the inside by pulling
it toward the rear.
The above illustration is of the CS500 model.
(5) Close the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
Take care not to get your fingers caught in the cover.

Table of Contents

Related product manuals