CS500/IS200 5 – 3
5. DAILY MAINTENANCE
5.3 Cleaning the Image Sensors
The scanner’s image quality drops when the transparent contact plates over the image
sensors become dirty, so clean the image sensors whenever necessary.
Procedure
(1) Turn off the scanner.
(2) Open the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
(3) As shown below, wipe off any soiled areas on the transparent contact plates using
a soft cloth that has been moistened with water or a neutral detergent (diluted with
water) and firmly wrung out.
Transparent contact plates
The above illustration is of the CS500 model.
(4) Completely remove any moisture on the transparent contact plates by wiping them off
again using a soft, dry cloth.
(5) Close the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
Take care not to get your fingers caught in the cover.
Do not use a commercial cleaner for office equipment, a glass cleaner, or chemical
solvents such as solutions containing alcohol.
To Next Page
Loading...
