GRAPHTEC CS500 - Index

CS500/IS200 Index – 1
INDEX
A
Assembling the scanner ............................ 2-1
C
Calibration ...................................................5-7
Caster ..........................................................2-7
Control panel ..............................................2-9
Cover sensor .............................................. 2-7
D
Daily maintenance ...................................... 5-1
Deviation due to scanner
specifications ...........................................6-4
Document hold-down unit .......................... 5-2
Document hold-down unit, cleaning the ....5-2
Document length ........................................4-1
Document support wire............................2-10
Document types..........................................4-1
Document with ............................................ 4-1
E
ERROR LED ....................................... 2-9, 6-2
Ethernet connector ..................................... 2-8
F
FORWARD key...........................................2-9
I
IEEE 1394 connector ................................. 2-8
Image sensors, cleaning the .....................5-3
Interface ......................................................1-1
M
Missing data ...............................................6-4
O
Overlapped data .........................................6-4
INDEX
P
PAPER LED................................................2-9
Paper sensor .............................................. 2-7
Paper sensor, cleaning the .......................5-5
Part Names and Functions .......................2-7
Power cable, connecting the .....................3-2
POWER LED ..............................................2-9
Power switch ..............................................2-8
R
REVERSE key ............................................2-9
S
Scanner, assembling the ........................... 2-1
Scanning Master 21+, installing the .......3-21
Stand ...........................................................2-7
STOP key ...................................................2-9
System requirements .................................3-1
T
Top cover .................................................... 5-1
Transparent contact plates ........................5-3
Troubleshooting ..........................................6-1
U
USB connector ...........................................2-8
Usage precautions ......................................viii
W
Warmup ........................................................viii