3 – 14 CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
3.5 Installing the Driver Software
The procedure outlined below is based on the requirement that you are logged on
to Windows with administrator rights. Consult your Windows 2000 or Windows XP
manual for more information.
For Windows 2000
The following procedure assumes that you are using the CS500-11 as part of your system,
and that you are using the USB interface. If you are using the IEEE 1394 interface,
GRAPHTEC CS500-11 IEEE 1394 SBP2 Device will be displayed where CS500-11 is
displayed when the USB interface is used. The scanner name displayed in the windows
is the name of the scanner connected to the computer (CS500-11 is used in this section).
(1) Connect the scanner to the computer, and turn on the computer’s power. Insert the
CD-ROM disk (included with your computer) into the CD-ROM drive of the computer
after Windows has started up, and then turn on the scanner’s power.
(2) [Next], the Found New Hardware Wizard appears.
To Next Page
Loading...
