CS500/IS200 3 – 13
3. PREPARING TO OPERATE THE SCANNER
Select the connected server, and then click [OK].
(4) Click [Register] to connect from the Utility.
(5) Click [Connect].
(6) After connecting with the Utility, specify the CS500-11eN/11eN-PRO or the IS200-11eN/
11eN-PRO driver as appropriate, and perform installation. For further details on the
installation procedure, refer to Section 3.5, “Installing the Driver Software”.
When using a CS500-11eN/11eN-PRO or the IS200-11eN/11eN-PRO connected to
an Ethernet interface, be sure to launch the Graphtec Network Utility and click the
[Connect] button. Furthermore, when you have finished using the scanner, click the
[Disconnect] button to put the scanner in a status that enables it to be used with other
computers.
If the [Connect] button is displayed in gray, the scanner is being used with another
computer. Please connect the scanner when the [Connect] button display returns to
black.
To Next Page
Loading...
