3 – 12 CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
Setting up the Graphtec Network Utility
(1) Set up the Graphtec Network Utility. Launch the utility from the Graphtec Network Utility
created in the Program folder.
(2) (2) Register the destination server. When the Utility is launched, the server registration
window appears.
In the Graphtec Network Utility, server refers to the scanner.
(3) Click [Yes] to perform registration of the server.
Note: Even if [No] is selected, you can still proceed to the registration window by clicking
When entering the IP address, enter both the [IP address] and the [Server Name].
Click [Search] to search for the destination server.
To Next Page
Loading...
