CS500/IS200 3 – 7
3. PREPARING TO OPERATE THE SCANNER
(4) Click [Device Setup]. The following window appears.
(5) Click [Next] to proceed
(6) The “Software License Agreement” window appears. Carefully read the provisions
of the agreement.
(7) Click [Yes] to continue with installation. The following window appears.
Specify the scanner’s IP address. Click [Search] and select the scanner.
Note: If the IP address wasn’t found during the initial setting procedure, there is a possibility
that there are two or more addresses with the factory setting (192.168.1.1) on the network.
To Next Page
Loading...
