3 – 20 CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
For Windows XP
The procedure outlined below assumes that the CS500-11 is connected in your system.
The scanner name displayed in the windows is the name of the scanner connected to the
computer (CS500-11 is used in this section).
(1) Launch the Control Panel using the Start menu.
(2) The screen shown below is displayed when you click on the “Printers and Other
Hardware” icon.
(3) The screen shown below is displayed when you click on the “Scanners and Cameras”
icon.
Check that “Graphtec CS500-11” is displayed here.
To Next Page
Loading...
