FC4200-UM-251-03-9370 7
NAMES OF THE MAIN PARTS
FC4210-60
(1) Pen carriage : Drives the cutter/pen to the left/right.
(2) Pen holder : Holds the cutter/pen and drives it up/down.
(3) Y bar : Holds the pen carriage; moves left/right.
(4) Writing panel : Cutting/plotting is performed here.
(5) Control panel : Used to set and use the plotterʼs various functions.
(6) Centronics parallel interface : Used to connect the plotter to a computer by cable via the Centronics-
connector compatible parallel interface.
(7) RS-232C serial interface : Used to connect the plotter to a computer by cable via the RS-232C
connector serial interface.
(8) AC line inlet : Connect one end of the power cord here and the other end to an
electri cal socket.
(9) Power switch : Controls the on/off status of the power supply to the plotter.
(6)
(7)
(1)
(3)
(4)
(2)
(5)
Pen holder
1 Pen holder 2
(8)
(9)
To Next Page
Loading...
