FC4200-UM-251-03-9370 1
INTRODUCTION
1. INTRODUCTION
This plotter incorporates a digital servo drive to perform cutting and plotting operations at high speed and
high precision.
Besides being used to cut marking film and other media, this plotter can also be used as a pen plotter.
1.1 Specifications
Specifications for the FC4200-50 and the FC4200-60
FC4200-50 FC4200-60
CPU 32-bit CPU
Configuration Flatbed cutting plotter
Drive system Fully-digital servo drive
Max. cutting area 590
×
430 mm 910
×
610 mm
Compatible media width 500 mm 666 mm
Max. cutting speed 65 cm/s
Specifiable cutting speeds 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60,65 cm/s
Cutting force 10 to 600 gf
Min. character size about 5 mm for alphanumerics (varies with the medium and font used)
Mechanical step size 0.005 mm
Programmable step size GP-GL: 0.1, 0.05, 0.025, 0.01 mm; HP-GL™: 0.025 mm*
1
Repeatability precision*
2
0.1 mm or less
Distance precision*
2
[Travelling distance
×
±0.2% or less] or ±0.1 mm, whichever is larger
Perpendicular precision 0.3/430 mm or les 0.4/610 mm or less
Registration mark reading precision*
3
within 0.3 mm
Max. no. of pens 2 pens can be concurrently mounted
Compatible blade type Supersteel, ceramic, and sapphire blades
Compatible pen types Water- and oil-based ballpoint pens
Compatible cutting media Marking film (polyvinyl, fluorescent, reflective)
Paper of 0.5-mm thickness or less (pattern paper, oilboard)*
4
Compressed polystyrene sheets of 0.8-mm thickness or less*
5
Sandblasting rubber of 1.5-mm thickness or less*
5
High-luminance reflective film*
6
Interfaces RS-232-C serial and Centronics-compatible parallel interfaces (automatic
selection)
Buffer capacity
2 Mbytes
Resident command sets GP-GL and HP-GL™ (selected at the control panel)
LCD display 20 characters x 2 lines
Rated power 100 to 120 VAC, 50/60 Hz; 220 to 240 VAC, 50 Hz (specify when ordering)
Power consumption 120 VA or less
Operating environment 10 to 35°C, 35 to 75% R.H. (non-condensing)
External dimensions (WxDxH) approx. 857 x 780 x 200 mm approx. 1172 x 964 x 200 mm
Weight (without stand) approx. 19 kg approx. 26 kg
*
1
HP-GL is a registered trademark of Hewlett-Packard Company.
*
2
The figure varies with the type of Graphtec-designated medium used and the currently selected cutting conditions.
*
3
Based on the precision when using the pen provided and high-grade paper to read this plotterʼs resident pattern.
*
4
For use with the CB15U or CB15U-K30 cutter blade.
*
5
For use with the CB15U-K30 cutter blade.
*
6
For use with the CB15UA cutter blade.
To Next Page
Loading...
