GRAPHTEC FC4200-60 - 2 Names of the Main Parts; Plotter Nomenclature

FC4200-UM-251-03-9370 6
NAMES OF THE MAIN PARTS
2. NAMES OF THE MAIN PARTS
2.1 Plotter Nomenclature
FC4200-50 / FC4200-60
(1) Pen carriage : Drives the cutter/pen to the left/right.
(2) Pen holder : Holds the cutter/pen and drives it up/down.
(3) Pen station : Holds a pen for plotting.
(4) Y bar : Holds the pen carriage; moves left/right.
(5) Writing panel : Cutting/plotting is performed here.
(6) Control panel : Used to set and use the plotterʼs various functions.
(7) Centronics parallel interface : Used to connect the plotter to a computer by cable via the Centronics-
connector compatible parallel interface.
(8) RS-232C serial interface : Used to connect the plotter to a computer by cable via the RS-232C
connector serial interface.
(9) AC line inlet : Connect one end of the power cord here and the other end to an
electri cal socket.
(10) Power switch : Controls the on/off status of the power supply to the plotter.
(11) CHART HOLD key (–50 only) : Used to hold the medium.
(8)
(7)
(10)
(9)
(1)
(2)
(3)
(6) (11)
Pen holder 1
Pen holder 2
Pen station
(4)
(5)