GRAPHTEC FC4200-60 - Default Chapter; Table of Contents

FC4200-UM-251-03-9370 iii
CONTENTS
CONTENTS
1. INTRODUCTION ........................................................................................................................... 1
1.1 Specifications ........................................................................................................................................1
1.2 Options ..................................................................................................................................................3
1.3 External Dimensions ............................................................................................................................. 4
2. NAMES OF THE MAIN PARTS ..................................................................................................... 6
2.1 Plotter Nomenclature .............................................................................................................................6
2.2 Control Panel .........................................................................................................................................8
3. The Tree Structure of Menus ....................................................................................................... 10
4. DAILY MAINTENANCE AND STORAGE .................................................................................... 12
5. LIST OF TOOLS .......................................................................................................................... 13
6. REPLACEMENT PROCEDURES ............................................................................................... 14
6.1 Precautions ......................................................................................................................................... 14
6.2 Removing the Y Rail Cover .................................................................................................................15
6.3 Removing the Front and Rear Y End Covers ......................................................................................15
6.4 Removing the Corner Cover ................................................................................................................16
6.5 Removing the Right Side Cover ..........................................................................................................16
6.6 Removing the Interface Cover .............................................................................................................17
6.7 Removing the Rear Cover ...................................................................................................................17
6.8 Removing the Operation Panel ...........................................................................................................18
6.9 Removing the Operation Tray ............................................................................................................. 18
6.10 Changing Pen Blocks ........................................................................................................................19
6.11 Adjusting the Pen Block Height .........................................................................................................21
6.12 Adjusting the X Belt Tension ..............................................................................................................22
6.13 Adjusting Y Belt Tension ....................................................................................................................23
6.14 Adjusting the X and Y Motor Synchro Belt Tension ...........................................................................24
6.15 Setting the Origin Position (FC4200-50) ........................................................................................... 25
6.16 Setting the Origin Position (FC4200-60) ........................................................................................... 26
6.17 Setting the Origin Position (FC4210-60) ........................................................................................... 27
6.18 About the Position of the Register Sensor Height .............................................................................28
6.19 Measure Seal Pasting Position (FC4200-50) ....................................................................................29
6.20 Measure Seal Pasting Position (FC4200-60) ....................................................................................30
6.21 Measure Seal Pasting Position (FC4210-60) ....................................................................................31
6.22 Pen Sense Rubber Pasting Position (FC4200-50 / -60 only) ............................................................32
6.23 Replacing the Main Board .................................................................................................................33