13
4
Connect the Power cable of Plotter.
Check that the Plotter power
source is turned off (the "
" side
is pressed down).
Connect the power source
cable.
Click the [OK].
5
Connect the Plotter to the PC using the USB cable, and
turn on the Plotter power source.
Connect it to the
Plotter.
Connect it to the PC
USB cable
Press Power switch "
|
".
When normally installed
"Start"
→
"Control panel"
→
"Hardware and Sound"
→
"Graphtec FC8600" appears on "Devices and
Printer". (For Windows 7)
6
The Device Driver will be installed.
Click the message.
Click the "Skip obtaining driver
software from Windows Update".
Click the [Yes].
Click the [Close].
CAUTION
Be sure to ground the earth terminal.
If the plotter is not grounded, the operator could
suffer an electric shock in the event of current
leakage.
To Next Page
Loading...
