GRAPHTEC FC8600 SERIES - Chapter 8: Settings Regarding Cutting Time; 8-1 Sorting the Cutting Data; 8-2 Perform Automatic Pre Feed When Cut Data is Received; 8-3 Perform Automatic Pre Feed When Media is Set (Initial Feed)

15
To connect using the RS-232C cable
2
Connect the Plotter to the PC using the RS-232C cable,
and turn on the Plotter power source.

Connect it to the PC
RS-232C cable

Press Power switch "
|
".

Connect it to
the Plotter.
Setting the port of PC
When RS-232C is used to connect, the port setting
for between PC and this machine should be
matched. For the port setting with PC, see Help in
Windows.
3
Check the machine for RS-232C setting.
4
Select the Interface.

Select the "COM1:
(Communication port)"
from Pull down list.

Click the [Next].
When normally installed
"Start"
→
"Control panel"
→
"Hardware and Sound"
→
"Graphtec FC8600" appears on "Devices and
Printer". (For Windows 7)
Click the [OK].
4.
Installing the Graphtec Studio
1
Click the [Setup Graphtec Studio] on the "Start" screen of
Installer.
For the Macintosh
See User's Manual contained in each language
folder inside attached DVD-ROM.