GRAPHTEC FC8600 SERIES - Chapter 7: Setting Regarding Cutting Quality; 7-1 To cut the corner of thick media sharply; 7-2 Setting the Step Pass; 7-3 Setting the Reference Angle

14
To connect using the Network cable
2
Select the Interface.

Select the "Standard TCP/
IP Port: (Network)" from
Pull down list.

Click the [Next].
3
Connect the Plotter to the PC using the USB cable, and
turn on the Plotter power source.
Network
cable

Connect it to the PC

Press Power switch "
|
".
Network
hub

Connect it to
the Plotter.
When IP address is not identifi ed
The IP address may vary depending on the network
environment. Consult with Network administrator.
For how to check the IP address of this machine,
see "Setting Interface" in FC8600 User's Manual.
P.9-2
4
Check the IP address of Plotter.
5
Input the IP address of Plotter.

Input the IP address.

Click the [Next].
The IP address on the screen is only for reference.
When normally installed
"Start"
→
"Control panel"
→
"Hardware and Sound"
→
"Graphtec FC8600" appears on "Devices and
Printer". (For Windows 7)
Click [OK].