GRAPHTEC FC8600 SERIES - Chapter 5: ARMS (Advanced Registration Mark Sensing System); 5-1 Outline of ARMS; 5-2 Setting and Adjustment of ARMS; 5-3 Setting the Position Using ARMS

12
3.
Installing the FC8600 Plotter Driver
Once installing of Cutting Plotter Controller is terminated, the
install screen of FC8600 Plotter Driver appears.
CAUTION
Do not connect
the Interface cable between Plotter
(FC8600) and PC before installing the FC8600
Plotter Driver.
1
Operate according to the instruction in the screen.
Click the [OK].
Click the [Next].
Click the [Next].
To connect using the USB cable
Port name
Select the "Port name" depending on the Interface
that is used.
Interface
Port
name
Next
procedure
To connect using the USB cable USB P.12
To connect using the Network
cable
TCP/IP P.14
To connect using the RS-232C
cable
COM1 P.15
To output the data for plotting into the
fi le without connecting to the plotter
FILE -
2
Select the Interface.

Select "USB" from Pull
down list.

Click the [Next].
The procedures vary depending on the selected Interfaces.
3
Install the Driver software.

Click the [Install].

Click the [CHECK BOX].