Mirror
P.4-6
This function allows the reversing for plotting origin point
and coordinate axes to be set.
Environmental setting
Setting the Plotting quality
Plotting range
P.4-2
Extension of plotting range
width
P. 4 - 4
Setting the cut line pattern
P.7-15
Manual positioning
adjustment
P.6-3
Set the plotting range arbitrarily. Also the origin point moves according to the
plotting range. It is impossible to plot at outside of the preset range.
Set the Increase/Decrease of plotting range based on the default value (edge at
inside of push roller).
Set whether cutting is made using the solid or dotted line (cut line).
Manually adjust the position of the media and tool, specify the position of the
registration marks (adjustment marks), and adjust the tilting of the axes and
distance. When impossible to read the registration marks through the ARMS, the
precision for both cutting the borders of the images plotted by different plotter and
re-cutting the media can be improved.
Dual confi guration
P.4-18
Apparel (AP) Mode
P.4-20
Two types of settings can be saved independently. Two-preferred sets of setting
can be stored separately if there are 2 operators, or 2 different settings for different
media can be stored, making a quick change when the media is switched.
Used when this Plotter is used in combination with CAD targeted for Apparel.
Distance adjustment
P.7-11
Tangent Emulation
P.7-2
Corrects the deviation in the length of cut or plotted line segments, which occurs
depending on the type or thickness of media being used.
Set it when cutting the thick media. Use this function when the blade tip gets sunk
into the media, making the blade hard to rotate so that, the start/end points are not
consistent or the corner does not get a sharp angle.
Rotation
P.3-10
This function allows the rotation for the plotting origin
point and coordinate axes to be set.
ARMS
P.5-2
A function to scan the registration mark written on the
media using sensors. The axis tilting, distance and 2
axes warp adjustment can be adjusted, besides this
function makes possible for a precise cutting when
cutting the borders of the images printed by the printer
or when cutting the media again.
To Next Page
Loading...
