GRAPHTEC FC8600 SERIES - Chapter 9: Setting Regarding Interface; 9-1 Setting Interface

16
2
Operate according to the instruction in the displayed
screen.
Click the [Next].
Click the [Next].
5.
Installing the Cutting Master 3
When Illustrator or CorelDRAW is
not used
No need to install
1
If you use Illustrator or CorelDRAW, click the [Setup
Cutting Master 3] on the "Start" screen of Installer.
For the Macintosh
See User's Manual contained in each language
folder inside attached DVD-ROM.
2
Operate according to the instruction in the displayed
screen.
Select the "Setup Cutting
Master 3".
Click the [Next].
Click the [Next].
Click the [Install].
Click the [Finish].
Click the [Install].
Click the [Finish].