GRAPHTEC FC8600 SERIES - Page 17

17
6.
Installing the User's Manual
1
Click the [Install User's Manual] on the "Start" screen of
Installer.
2
Operate according to the instruction in the displayed
screen.
Select the "Install User's
Manual".
Click [Next].
Click [Finish].
The installed User`s manual is registered in Start menu
of Windows.
1.
Setting the media (paper)
For the FC8600, the roll media and sheet media can be used. The feeding method includes rear loading (feeding
from rear side) and front loading (feeding from front side). Select it depending on the assembled way of Plotter.
Media
The setup methods vary depending on the media
type, width and loading method. See the page
stated in the "Next procedure" of the following
conditions table.
Media
type
Media width
Loading
method
Next
procedure
Roll
media
160 to 540mm F/R P.18
540mm or over F/R P.19
Sheet
media
100 to 160mm F/R P.19
160mm or over F/R P.19
If the roll media is used
Explained here is the operation method that is used for rear loading. For use in
front loading, see the column shown at right.
Setting up the Plotter main unit