18
1
Lower the Media set lever to raise the push rollers.
Media set lever
Lower the
Media set
lever.
Push roller
Media sensor
Once the Media set lever is lowered, "LOAD
MEDIA!" appears on LCD.
2
Insert the media through the bottom of push roller.
Raise the Media lock, (
), put the roll media so that the extracted
portion faces up (
), and extract the media to such a degree that it
covers the top of media sensor. (
)
*
Cutting media should be placed above media censor at any time.
Put the Roll media on
the Media bracket.
Media bracket
Media lock
Media sensor
Extract the Media.
Raise the Media lock
(lock).
Media lock
A stopper, which is used to prevent the stock rollers
from rotating when setting the roll media. The media
lock ensures that the media is pulled straight out
from the roll.
When the media width is 160 to 540 mm
Position of Push roller
For the adjustment of Push roller position, see
"Aligning the Push Roller" in FC8600 User's Manual.
P.2-13
Standby position
For the standby position, see "Standby of Push
Roller" in FC8600 User's Manual.
P.2-13
3
Set the positions of two push rollers.
Push both ends of media so that it comes over the media sensor, and
set the push rollers so that they comes over the grit rollers. (
) Move the
push rollers, that are not used, to the Standby position. (
)
Push roller
Push roller
Grit roller
Media
Media sensor
After setting, go to the procedure 4.
Standby position
For front loading
Media set lever
The Stock tray is mounted at front side.
For front loading
Media lock
To Next Page
Loading...
