19
When the media width exceeds 540 mm
Position of Push roller
For the adjustment of Push roller position, see
"Aligning the Push Roller" in FC8600 User's Manual.
P.2-13
Standby position
For the standby position, see "Standby of Push
Roller" in FC8600 User's Manual.
P.2-13
3
Set the positions of three push rollers.
Push both ends and center of the media so that it comes over the media
sensor, and set the push rollers so that they comes over the grit rollers.
(
) Move the push rollers, that are not used, to the Standby position. (
)
Push roller
Grit roller
Media
Media sensor
4
Take up the slack of roll media, and fix it with the Push
rollers.
Pull the edge to take up the slack.
Lower the Media
lock (Cancel).
Media set lever
Raise the Media set lever.
The MEDIA FEEDING METHOD
SELECTION screen appears.
If the sheet media is used
1
Lower the media set lever to raise the Push rollers. (See "If
the roll media is used".)
2
Insert the media through the bottom of Push roller. (See "If
the roll media is used".)
When the media width is 100 to 160mm
3
Set the positions of two Push rollers.
Push both ends of media so that it comes over the top of Media sensor,
and position the Push rollers while the left edge of grit roller is being set
as the starting point so that the Push roller come over the lengthy grit
rollers at right edge. (
) Move the Push rollers, that are not used, to the
Standby position. (
)
Push roller
Origin point
Grit rollerMedia
Media sensor
Set the Media and
Push rollers on the
lengthy Grit roller.
Move away the Push
roller that is not used.
Switching the pressure of push
rollers
When you cut with 3 or more push rollers, switch
the center push roller .Refer to FC8600 user`s
manual.
P.2-13
Position of Push roller
For the adjustment of Push roller position, see
"Aligning the Push Roller" in FC8600 User's Manual.
P.2-13
Standby position
For the standby position, see "Standby of Push
Roller" in FC8600 User's Manual.
P.2-13
When the media width exceeds
161mm
See "If the roll media is used".
For front loading
Media lock
Media
set
lever
To Next Page
Loading...
