20
4
Take up the slack of roll media, and fix it with the Push
rollers. (See "If the roll media is used".)
2.
Set the media type into the Plotter.
Set the media type into the Plotter depending on the preset media.
To change the loading method
It is set to rear loading in the initial setting. If setup
was made according to Front loading, change the
loading method. For the change of loading method,
see "Setting Feeding Method" in FC8600 User's
Manual.
P.2-19
Display of "CONTINUE"
Depending on the status of Plotter, the fourth option
"CONTINUE" may appear.
To reset the similar media and to continue the same
setting as is during plotting, select the "CONTINUE".
It appears when Media set lever is raised/lowered
after setting the media.
1
Select the type of the loaded media.
Use the keys numbered [1] to [4] of Control panel to select.
Roll media
Plot starting with the edge of media. [1]
Plot starting with the preset position. [2]
Sheet media [3]
When similar media is reset [4]
Once the media is set, the next screen appears.
The MEDIA FEEDING METHOD
SELECTION screen appears.
Ready status
The "READY" appears on LCD when PC data
receiving enabling status is achieved in Plotter.
Default screen
When power source of main unit is turned on, the
screen after version displayed is called "DEFAULT
SCREEN".
2
Wait until the Plotter detects the media size and setting
completes.
Once completed, the next screen appears.
"READY" appears.
This screen is called as "Ready status".
3.
Attaching the Tool
Attach a tool (cutter plunger, plotter pen) to the Plotter. It is explained here using cutter plunger as an example.
CAUTION
Do not touch the Tool edge when power is turned on
or during operation.
1
Loosen the Tool holder screw.
To Next Page
Loading...
