21
2
Attach the tool on the Tool holder.
While pushing the Tool holder in the upward direction, push the tool all
the way into the holder until its fl ange contacts the upper part of the Tool
holder.
Flange
Upper part of
Tool holder
For half cutting
(innermost side: Tool 1)
For cutting out (forward side: Tool 3)
CAUTION
Do not over tighten the screw during fi xing. When
the screw is loosened and disconnected, connect it
again.
The pouncing pen (option) should be connected on
the Tool 1 by all means.
3
Fix the Tool.
Make sure that the Tool bracket is engaged on the tool's fl ange, and
then tighten the screw.
Flange
Bracket to hold
tool
4.
Note on use when you mount the tool on the FC8600
The tool may be tilted when mounted.
In this case, please follow right procedure to mount the tool correctly.
1
Screw the tool holder screwloosely.
2
Pull up the tool while turnit one-quarter to mount it
vertically.
3
Tighten the tool holder screw after the tool is mounted
vertically
CAUTION
When pushing the Tool holder with your fi ngers, the
blade tip may be protruding. Take care not to cut
your fi ngers.
Half cutting and Cutting out
The cutting operation is different depending on the
position of Tool holder where the Tool is inserted.
Mainly, the forward side is used for Cutting out, and
innermost side is for Half cutting.
For Cutting out and Half cutting, see "Attaching a
Tool" in FC8600 User's Manual.
P.2-4
To Next Page
Loading...
