22
5.
Tool adjustment and test cutting
After setting the Tool/Speed/Force/Acceleration, make test cutting, and repeat until optimal condition is
achieved.
CAUTION
Do not touch the Tool edge when power is turned on
or during operation.
1
Press the [CONDITION] key in the Default screen.
CONDITION screen (1/3) appears.
Setting the Tool conditions
For detailed setting methods of each plotting
condition, see "Selecting Tool conditions" in FC8600
User's Manual.
P.2-24
2
Set the Tool conditions (Tool, Speed, Force, Acceleration).
eg.) Screen for Tool setting
Press the [ENTER].
To make 1 cut with set value
3
Make test cutting for one piece while Tool conditions are
being set.
CONDITION screen (1/3) appears.
Press the POSITION [
◄
] key.
Press the POSITION (
▲▼◄►
) key so that the Tool carriage moves
to the location you wish to perform the test cutting.
Tool carriage
Press the [ENTER] key.
To make 3 cuts with set value and ±1 of set value
3
Make test cutting for three pieces while Tool conditions are
being set.
CONDITION screen (1/3) appears.
To Next Page
Loading...
