11
2.
Installing the Cutting Plotter Controller
1
Click the [Install FC8600 Software] in the [Start] screen of
Installer.
Select "Install FC8600
Software".
For the [Install FC8600 Software], both "Cutting Plotter Controller"
and "FC8600 Plotter Driver" will be installed.
Corresponding PC
To use the Cutting Plotter Controller, use PC of
Windows 8/7/Vista/XP and connect using the USB/
LAN (Network)/RS-232C Interface.
The Cutting Plotter Controller is the software, which
provides the similar operation as that of control
panel of Plotter through the PC. If your Windows and
Interface being used are different from the above
mentioned, use the Control panel to operate.
2
Operate according to the instruction in the displayed
screen.
Click [Next].
* To install only FC8600 Driver Software,
press [Cancel].
Click [Next].
Click [Next].
Click [Finish].
CAUTION
Do not connect
the Interface cable between Plotter
(FC8600) and PC before installing the FC8600
Plotter Driver.
To Next Page
Loading...
