10
1
The Windows [AutoPlay] screen will appear.
Select [Run MultiSetup.exe] from the Windows [AutoPlay]
screen.
*
If the [AutoPlay] screen does not appear, open [Explorer] and
select the DVD drive containing the software to be installed.
Open the DVD and double-click on [MultiSetup.exe].
2
Click [Yes] if you have logged on using an administrator
account.
Click [Yes].
If you have logged on using a standard user account, an [User
Account Control] screen asking you to enter the administrator
account password may appear.
Enter the password, and then click [Yes].
Click [Yes].
3
The [Start] will appear.
"Use this menu to install the software you require to use the
FC8600.
First-time users should proceed with installation by clicking on
[Install FC8600 Software]."
Proceed with installation according to your operating
environment.
When auto play of software is not
set
For Windows 7/Vista :
1. Select [Run MultiSetup.exe] from [Autoplay]
Selection menu of Windows.
When [Autoplay] Selection menu does not
appear :
1. Select the DVD/CD-ROM Drive from Computer, and select
[Open] with right clicked.
2. Select the [MultiSetup.exe], and double click it.
* Also for Windows XP take the same manner.
Enter the password.
Install FC8600 Software:
Install the [Cutting Plotter Controller] and [Plotter
Driver].
The [Cutting Plotter Controller] enables various
cutting conditions, plotter settings, etc. to be
controlled directly from your computer.
Setup Graphtec Studio:
Software enabling cutting data to be created
through simple commands.
Create designs and edit characters/shapes using
this software."
Setup Cutting Master 3:
Plug-in driver that enables simple cutting through
direct operation from within Adobe Illustrator and
CorelDRAW.
Install User's Manual:
Installs the FC8600 User's Manual.
To Next Page
Loading...
