24
2
Turn the Blade length adjustment knob of Cutter plunger to
the left to fully retract the blade.
Plunger
Blade length
adjustment knob
Plunger-cap
(Blue : For 0.9 mm
diameter blades)
(Red : For 1.5 mm
diameter blade)
Cutter blade
3
Control the panel according to the following procedures.
Press the [ENTER] key.
BLADE LENGTH setting screen appears.
CAUTION
When the [1] key (BLADE LENGTH TARGET) is
pressed, the Tool carriage will start moving, so take
care not to cut your fi ngers.
Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen appears.
Press the POSITION [
▲▼
] key to increase or decrease the setting value.
It will get set and return to BLADE LENGTH setting screen by pressing
the POSITION [
◄
] key (PREVIOUS).
CAUTION
When the [2] key (CHECK) is pressed, the Tool
carriage will start moving, so take care not to cut
your fi ngers.
Press the [2] key (CHECK).
The amount and direction for turning the
adjustment knob are displayed.
4
Turn the Blade length adjustment knob to adjust the cutter
blade length.
Current blade length is displayed by pressing the [2] key
(CHECK), so adjust the blade length until it matches the
thickness of the media.
Press the [3] key (END).
Press the [CONDITION] key.
CAUTION
To avoid bodily injury, handle cutter blades with care.
Blade length adjustment knob
Adjust the blade length by turning the Blade length
adjustment knob. To protrude the blade, turn in
the direction of "A". To retract the blade, turn in
the direction of "B". When the knob is turned by
one scale unit, the blade moves approximately
0.1 mm. One full turn of the knob moves the blade
approximately 0.5 mm.
Cutter blade moves
approximately 0.1 mm
turning one scale unit
621639960
Scale
Scale
To Previous Page
Loading...
