Settings and Measurement
3-3
(2) RANGE/SPAN/POSITION key
These settings can be made or changed for each channel individually, even while the GL450 is
running or performing measurement.
CHECKPOINT
The monitor is used for monitoring the measurement status only, and its settings cannot be changed. In
addition, the RANGE setting can only be changed if data has not been captured.
Selecting the Items
Press the RANGE/SPAN/POSITION key to switch from one setting screen to the next.
Waveform + Digital
(for monitoring
measurement only)
(only when data
has not been captured)
(only when data
has not been captured)
INPUT RANGE SPAN POSITION
Waveform + Digital INPUT RANGE settings SPAN settings
POSITION settings
Setting Procedure
Use the direction keys to move to the setting item and to make selections (settings).
QUIT MENU
LOCAL
ENTER
CH settings
Select (set)
INPUT settings
OFF, Voltage, Temperature, Humidity
RANGE settings
The voltage and temperature settings vary according to the settings made in MENU (AMP).
• Voltage
20 • 50 • 100 • 200 • 500 mV • 1 • 2 • 5 • 10 • 20 • 50 • 1–5 V
• Temperature
TC-K • TC-J • TC-T • TC-R • TC-E • TC-B • TC-S • TC-N • TC-W • Pt100 • JPt100
To Next Page
Loading...
