GRAPHTEC GL450 - Report

4-26
Software
Report
Daily or monthly reports can be generated during data measurement.
(1) Report
Daily Capture: Check this box to enable report data to be generated daily.
Capture Interval: 1, 5, 10, 30 seconds, 1, 5, 10, 30 minutes
A daily capture file is automatically created for the measured data according
to the capture interval specified.
Monthly Capture: Check this box to enable report data to be generated monthly.
Capture Interval: 1, 5, 10, 30 minutes, 1, 2, 6, 12, 24 hours
A monthly capture file is automatically created for the measured data
according to the capture interval specified.
Output method: Select the output format. Save the data as a CSV file, or export it to a direct
Excel file.
(2) Configure CSV file
Daily Capture (Save Destination Folder):
Specifies the folder for saving daily capture data. The file name becomes "Daily Date
Time.csv".
Monthly Capture (Save Destination Folder):
Specifies the folder for saving monthly capture data. The file name becomes "Monthly
Date Time.csv".
(3) Configure to transfer to Excel
Template file: Specifies the Excel file for export.
CHECKPOINT
• There are several templates stored in the Temp folder contained in the installed OPS022 folder.
Use one of these templates or create your own template if desired.
• Daily capture and monthly capture data can be exported to separate sheets in the same Excel file.
Daily Capture:
• Export Destination Sheet:
Specifies the export sheet name for the Excel file specified by the template file.
• Start Cell: Specifies the start cell position on the export sheet.
Monthly Capture:
• Export Destination Sheet:
Specifies the export sheet name for the Excel file specified by the template file.