4-32
Software
Waveform View
The waveform view "Y-T" display can be selected as "Single View" or "Dual View". When the GL450 is
in on-line status, the measured waveforms are always displayed. Moreover, when data capture has
been started, the data is captured according to the settings made in the setting menus.
Y-T
Measurements can be displayed with respect to the time axis.
(1) Single View Display
The X axis is the time axis, and the Y axis displays the measurement range specified for each
channel.
Y Axis Range 1, 2: The Y axis scale can be displayed as the scale for two channels.
Channel If a channel's color display is clicked to turn it off, the waveform for that
channel will not be displayed.
X-axis Display Width: The time axis width can be changed if the numeric value is changed.
Note: Measurement data is captured.
Format: Second, Relative Time, or Absolute Time can be selected for the X-axis
display.
Comment Function: During data capture, a comment can be input above the Y axis range 1
waveform. Comments that were input can be checked during a Review
PC operation, and can also be changed or added to if required.
Note: This function is only enabled during data capture.
To Next Page
Loading...
