4-10
Software
4.5 Setting the IP Address and Device ID
The GL450 Configuration Tools window is used to set the IP address, and Device ID. For details, see
Chapter 3, "Settings and Measurement".
IP address: Used when measuring via a network.
Subnet Mask: Used when measuring via a network.
Mac Address: Used to confirm the Mac address.
Port Number: Used when measuring via a network.
Device ID: Used when measuring via USB.
Firmware Version: Used to check each version number.
CHECKPOINT
• When setting the IP address, port number, or device ID using the Configuration Tools, the GL450
should be connected directly to the PC using a USB cable.
• When using Configuration Tools, they should be connected separately, and not via a USB hub.
• When connecting via LAN, make the settings outlined below and then ensure that the computer's
system requirements are met before making the connections.
(1) Connect the GL450 to the PC using a USB cable.
Select "Start" → "Programs" → "OPS022" → "GLCONFIG.EXE" to launch the GL450
Configuration Tools and display the window as shown below.
(2) LAN Settings
Click "Read" to display the current setting. To set a new IP Address, Subnet Mask and/or Port
Number, enter the new settings and then click "Apply".
(3) USB Settings
Click "Read" to display the current setting. To set a new Device ID, enter the new Device ID
number and then click "Apply".
(4) Firmware Version
Click "Read" to display the Main version number. Use this function to check the version
number of your equipment.
(5) After setting, exit from GL450 Configuration Tools.
To Next Page
Loading...
