GRAPHTEC GL450 - Data

Software
4-21
Data
Click the "Data" button to set measurement parameters, the data capture destination, etc.
(1) Device Settings
Sampling Interval: 100, 200, 500 ms, 1, 2, 5, 10, 20, 30 s, 1, 2, 5, 10, 20, 30 min, 1 h
Specifies the sampling speed for the GL450.
CHECKPOINT
The maximum sampling interval that can be set is limited by the number of channels installed.
Data Capture Setting: Internal memory, PC card
(2) PC Card Settings
File Name: Specifies the file name for data capture.
Format: GBD, CSV
Specifies the data format for saving measurement data
File Path: Specifies the file path when saving data to a PC card.
(3) PC Settings
Capture File Name: Specifies the file name when data is captured to the computer.
Format: GBD, CSV
Specifies tmhe data format for saving measurement data.
Auto File Name: Specifies a file name automatically. The date and time are appended to
the file name.
CHECKPOINT
When the setting is Auto File Name, a folder labeled with the date on which data capture started
is created, and the data is stored to that folder.
Example: If the date is June 1, 2005, the data is stored to
Specified folder \2005-06-01\
File Path: Specifies the file path when saving data to a computer.
(4) Auto Backup Settings
Create Backup File: Check this box for auto data backup.
Backup Interval: 1, 2, 6, 12, 24 hours
Specifies the backup interval.
CHECKPOINT
• The data backup location uses the same file path set in PC Settings. The file name is automatically
assigned.
• PC Settings Capture File Name _xx_bk.GBD (xx: consecutive numbers).