Settings and Measurement
3-29
Cursor Position ................... There are other functions for Cursor Move apart from the Alarm
Search function.
Move to First Data: Moves the cursor to the start of the data.
Move to Last Data: Moves the cursor to the end of the data.
Move to Center: Moves the cursor to the center of the data.
Move to Selected Position: Specify the cursor position to be moved to.
•Position:
Move at the specified time from the start of measurement. Interval
until the end of measurement, in 0.1-s units
•Time: Move to the specified date/time.
Cursor Sync ........................ Moves cursors A and B simultaneously. Cursor A is always the
fulcrum.
Search ................................ This function searches for the alarm setting position within the
captured data.
Alarm Output No.: Specify a number that has been set for the alarm
settings (1 to 4).
Setting Selections available Setting method
Cursor Position Move to First Data ENTER
Move to Last Data ENTER
Move to Center ENTER
Move to Selected Position
• Selected method: Position, Time ENTER→Select→ENTER
• Position Moved To (Position only) Between
ENTER→Specify numeric value
Upper and Lower Limit Values
→ENTER
(Time only) Specified time
ENTER→Specify numeric value
→ENTER
• Execute ENTER
Cursor Sync Off, On ENTER→Select→ENTER
Search Alarm Output No.: 1 to 4 ENTER→Select→ENTER
Alarm Slope: Both, Hi, Lo ENTER→Select→ENTER
Next Alarm Match ENTER
Prev. Alarm Match ENTER
Statistical Calculation Function: Off, Average, Max, Min, Peak, RMS ENTER→Select→ENTER
Specification Channels ENTER→Select→ENTER
Select channels from the input terminal unit: 2 ch
To Next Page
Loading...
