3-42
CHAPTER 3 Settings and Measurement
(1)-45 Other setting
The following settings can be performed.
Setting Description
Annotation text string Set the annotation (comment) displayed in the CH.
Program Inter-CH
calculation
Set the contents of Program Inter-CH calculation.
Four arithmetic operations (addition (+), subtraction (-), multiplication (x), division (÷)) can be used for
the Program Inter-CH calculation.
* For detaols, refer to “<Inter-CH Op Settings>” in “(1)-6 Misc.” in “3.4 Setting Menus”.
Span setting Set the upper and lower limits of the span which the waveform is displayed.
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Amplitude Setting 1 to 8 dots
Trace This is used to set the waveform display.
Voltage value
(Power only)
Set the measurement voltage value to calculate the power within the range of 90 to 264V.
Power factor (Power only) Set the power factor to calculate the power within the range of 0.30 to1.00.
Auto zero adjustment The current input current value is calculated as a zero point current value.
Automatic adjustable current range is within ±10% of set range.
Zero adjustment reset Reset the zero point current value.
* This function is not applied to power measurement.
[Zero point voltage value] Display the zero point current value.
* This function is not applied to power measurement.
To Next Page
Loading...
