GRAPHTEC GL840 - Page 141

3-65
CHAPTER 3 Settings and Measurement
(4)-3 Wireless LAN setting
This is used to set the conditions when connecting the GL840 to wireless LAN.
This screen is not displayed unless the wireless unit is installed to the GL840.
Station settings Access point settings
(1) Perform the wireless LAN settings.
Selection item Description
Off The wireless LAN is not used.
Station The GL840 is set to wireless LAN remote unit.
Access point The GL840 is set to wireless LAN base unit.
(2) Restart the wireless LAN.
When restarting after selecting the wireless LAN, the information of the station or the access point is
displayed.
It takes some time to display.
•
Access point (operated as base unit)
This is the settings for connecting between the GL840 and the separately sold Petit LOGGER GL100-WL
(up to 5 units) via wireless LAN.
•
Station (operated as remote unit)
This is the settings for controlling from a PC and transferring data to a PC after connecting to the
separately sold wireless LAN base unit.
•
After executing "Wireless LAN restart" once, the wireless LAN cannot selected. When the wireless LAN
selection is changed, the restart is enabled.
•
"Disconnect" "Wireless LAN restarting" "TCP-IP restarting" are executed.