3-68
CHAPTER 3 Settings and Measurement
(3) Search the SSID.
Press the key. The searched SSID list is displayed after searching the SSID.
In Step (2), when the SSID is selected from this list, the SSID will be automatically reected.
(4) Set the encryption method.
WEP or WPA-PSK/WPA2-PSK settings can be performed. When this setting is selected, the “WEP key”
is displayed. Enter in accordance with the procedure of "(8) Character string input" described below.
(5) Set the wireless standard 11n.
When the IEEE802.11n is used, set to "ON".
(6) When the above settings are nished, press the key to execute the "Apply settings".
The settings are saved.
(7) The wireless LAN is enabled by executing the “Connect/Disconnect” in the “Other settings”.
Effective display
Other settings when setting the station
When connecting to the wireless LAN after setting the station, by pressing the [Connect/Disconnect] key, the
“Restart TCP-IP” is displayed and then the connection is established.
To disconnect the wireless LAN during the connection, press the [Connect/Disconnect] key again.
When you want to change the connection conditions, perform the "ST-IP setting".
• When the “IP Addr Auto Acq.” is used, select the “On”.
• When the “IP Addr Auto Acq.” Is not used, select the “Off” and then set the IP address, Subnet masuk, and
Port number, etc.
After the above setting, press the Key of "Apply settings" in the “ST-IP setting”. The “Restart TCP-IP” is
displayed and the setting operation is completed.
To Next Page
Loading...
