GRAPHTEC GL840 - Page 161

3-85
CHAPTER 3 Settings and Measurement
Move the cursor to the le or folder you want to delete and then press the [ENTER] key. The "√" mark is
displayed in the checkbox. (Multiple les/folders can be selected)
Press the [ENTER] key again to cancel it.
When it is cancelled, the "√" mark will disappear.
The selection is completed by pressing the [QUIT] key.
(2) Enable the deletion.
The message of “Delete the le. All the data will be lost. Are you sure?” is displayed.
The les are deleted by operating the [ENTER] key again.
(6)-2 Data Save
During replaying the data, the displayed data can be saved in the internal memory (SD1) or SD CARD (SD2)
by selecting the Data Save in the File Menu.
<If the Name Type is Auto> <If the Name Type is User (Arbitrary)>
(1)
(2)
(3)
(4)
(1)
(2)
(3)
(4)
(5)
Setting Description
(1) File Type Sets the le format used to save data.
GBD: Creating a data le in Graphtec's proprietary binary format.
* Data tampering can be prevented.
CSV: Creating a data le in text format.
(2) Name Type Sets how a data le should be named.
Auto : Automatically supplies the le name.
Example : 20150201-123456.GBD
Number part : File creation date
* The le is created on February 1, 2015, 12:34:56 in this example.
GBD : Data format
GBD (Binary data)
CSV (Text format)
User : Data is captured to a le with an entered le name.
Sequential number : A le is created with an arbitrary le name that has been entered,
followed by a sequential number.
(3) Folder Specify a folder to which you want to capture (or save) data. For details, refer to "(7) File
box".
(4) Save Range Set the data range to be saved.
All data : All of the data is saved regardless of the cursor operation.
Data between cursors : Only the data in the range between cursors A and B is saved.
(5) File Specify a folder to which you want to capture (or save) data. For details, refer to "(7) File
box".