GRAPHTEC GL840 - Page 168

To Next Page

To Previous Page

3-92

CHAPTER 3 Settings and Measurement

(9) Data replay menu

Select the data you want to replay from the “Data replay source” by pressing the [REV1EW] key and replay

the captured data.

Select items Description

File Name Specify the le in the capture destination (save destination).

Checksum verication Veifying checksum

The checksum conrmation result is displayed in the dialog.

When checksums match: "Checksum matched"

In case of checksum mismatch: "Checksum mismatched"

For CSV-formatted data, only the data captured by this GL840 can be replayed.

"Checksum verication" is displayed only when selecting a GBD le to which a checksum is attached. For

details on how to add a checksum, refer to "3.4 Setting Menu" - "(5)-9 Add checksum to le".

Data replay menus are displayed by pressing the [MENU] key during replay.

Setting Selections available

Cursor

Position

Move to First Data

Press right key to execute.

Move to Last Data Press right key to execute.

Move to Center Press right key to execute.

Move to

Selected Position

Method: Position, Time

[Position] Position 0 to end of data

For example, if the sampling interval is 100 ms, capture

destination is the built-in RAM, and the number of capture

points is 10000, settings up to 999.9 ms are available.

[Time] Date Date from the start to end of the data

Time Time from the start to end of the data

Cursor Synch Off, On

Other manuals for GRAPHTEC GL840