3-93
CHAPTER 3 Settings and Measurement
Setting Selections available
Data search CH CH1 to 200, Logic, Pulse, Alarm
* Logic and Pulse are displayed only if the Logic Pulse
function is On in the AMP settings.
[CH1 to CH200]/GS/WL CH1-200, GS1 to 8, WL1-1 to WL5-8
[Logic] Logic1-28
[Pulse] Pulse1-28
[Alarm] Alarm1-10, WL1-5
Mode [CH1 to CH200]/GS/WL
↑
H,
↓
L
[Logic]
↑
H,
↓
L
[Pulse]
↑
H,
↓
L
[Alarm] Both,
↑
H,
↓
L
Level [CH1 to CH200]/GS/WL Set numeric value
[Pulse] Set numeric value
Find Next Press right key to execute.
Find Previous Press right key to execute.
Statistical
calculation
between cursors
Function Off, Average, Max, Min, Peak, RMS
Execute Press right key to execute.
(9)-1 Move to First Data
Executing this option moves the currently selected cursor (A or B) to the start of the data.
(9)-2 Move to Last Data
Executing this option moves the currently selected cursor (A or B) to the end of the data.
(9)-3 Move to Center
Executing this option moves the currently selected cursor (A or B) to the center of the data.
(9)-4 Move to Selected Position
Sets a position (relative position in time) or time and moves the currently selected cursor (A or B) to this
position or time.
<If the Method is Position> <If the Method is Time>
(1)
(2)
(1)
(2)
Setting Selections available
(1) Method Sets the method for specifying the position to move the cursor to.
Select Position or Time.
(2) Move to Sets the position to move the cursor to. Specify how far down you want to move the cursor
from the capture start position assumed as 0.
Only positions down to the end of the data can be set. Check the setting range in the (A)
part.
(3) Time Sets the position to move the cursor to using a date and time.
Only positions from the start to the end of the data can be set. Check the setting range in the
(B) part.
To Next Page
Loading...
