3-101
CHAPTER 3 Settings and Measurement
4. After setting, when the "Next >>" is selected and then the [ENTER] key is pressed, the setting information
and notes on measurement are displayed.
When the "Finished" is displayed, the operation exits by pressing the [ENTER] key.
When you want to nish the operation in the middle, the operation can be nished by pressing the [NAVI]
or [QUIT] key.
The basic work ow to perform "Easy Capture Settings" is as above.
The setting procedure varies depending on the other setting item. However, you can set them by operating
in accordance with the instructions displayed on the menu.
To connect the wireless sensor or the remote terminal to the GL840, you must turn off the power of the
GL840. Follow the following procedure to connect it.
(1) Turn off the power of the GL840 once.
(2) Turn on the power of the GL840 and wait for it to start up completely.
(3) Check whether the GL840 has recognized the wireless sensor or the remote terminal with the remote
unit icon at the top of the GL840’s display.
: The unit search is not completed correctly.
: The unit is recognized.
To Next Page
Loading...
