GRAPHTEC midi LOGGER GL240 - Page 104

3-62
CHAPTER 3 Settings and Measurement
Conrmation of setting completion
Conrm on the AMP Setting screen that the wireless sensor is recognized.
AMP Setting screen
AMP Setting screen
WL displayed group
Channel group switching
Run power cycle.
Change the settings in the following two ways.
• Open the AMP setting screen.
Change the CH1-CH10 displays to WL1-WL8 display groups.
Alternatively, press the [FILE/GROUP] key, and then select the WL1-WL8 from the channel group.
Make sure that the information of WL group is the same as those of selected wireless sensor.
<Example 2 of operation procedure>: Example of wireless sensor (GL100-WL) connection
The wireless connection method when setting the GL240 to “Access Point” and the GL100 to “Station” is
described.
[LAN setting]
(1) Set the wireless LAN to "Access point".
(2) Then, select the “Restart the wireless LAN”.
When the is displayed and the restart is completed, the following screen is displayed.
(3) Set the SSID of the GL240.
Enter the “GTC_GL240_01”.
For details on entering the characters, refer to “(9) Text input”.
(4) Set the other items.
Encryption method: None, Channel: 1ch, Stealth: Off, 11n: On
(5) After setting the above items, be sure to select the “Reection of setting” (" " key) to reect them.
The "Wireless LAN restart" is automatically executed and then the settings is reected.
[Other settings]
(6) Make sure the IP address of wireless LAN. When the “AP-IP setting” is selected, the following dialog is
displayed.
Set the segment of IP address and select the " Reection of setting”. The settings of subnet mask and
port number other than the segment are xed.