3-63
CHAPTER 3 Settings and Measurement
(7) Then, set the [I/F] of the GL100-WL.
• Wireless LAN mode: Station
• DHCP: On
• SSID: GTC_GL240_01
• Security: Off
<Example of GL100-WL screen setting>
［ Ｉ／Ｆ］ ６／１０
ＷＬＡＮ Ｍｏｄｅ：Ｓｔａｔｉｏｎ▽
ＤＨＣＰ：Ｏｎ▽
ＴＣＰ／ＩＰ：▽
ＳＳＩＤ：ＧＴＣ＿ＧＬ２４０＿０１▽
Ｓｅｃｕｒｉｔｙ：Ｏｆｆ▽
Ｋｅｙ：＊＊＊＊＊＊＊＊＊＊＊＊▽
•
Set the GL100-WL settings in reference to GL100-WL User’s Manual. The keys required to set are as
follows;
QUIT MENU
STATUS
POWER
ENTER
START
STOP
• [MENU] key : The measurement condition settings and the information of the GL240 are displayed.
• key : Used to select during MENU operation.
• [ENTER] key : Used to conrm during MENU operation.
• [QUIT] key :
Used to return the previous screen or display the free-running screen during MENU setting.
(8) Search the sensor to be connected in the “Wireless LAN setting”.
When the “Wireless LAN setting” is selected, the following dialog is displayed.
When the “Search” is selected to connect the wireless sensor GL100-WL, the connectable device names
are displayed. If the list of the connectable wireless sensors is not displayed, repeat to search until it is
displayed.
* It might not be able to search depending on the radio wave state. Also, if the "LAN" is not displayed at
the bottom on the LCD display of the GL100-WL, review the power status and settings.
Then, the device name is automatically is registered by selecting device name to be connected from the
displayed wireless sensor list.
To Next Page
Loading...
