3-32
CHAPTER 3 Settings and Measurement
(1)-16 Other setting
The following settings can be performed.
Setting Description
Annotation text string Set the annotation (comment) displayed in the CH.
Program Inter-CH
calculation
Set the contents of Program Inter-CH calculation
Four arithmetic operations (addition (+), subtraction (-), multiplication (x), division (÷)) can be used for
the Program Inter-CH calculation
Span setting Set the upper and lower limits of the span which the waveform is displayed.
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Line Thickness Setting 1 to 8 dots
Trace This is used to set the waveform display.
Reference temperature
(Accumulated
temperature only)
Set the reference temperature accumulated within the range of -20 to +85°C
Reference temperature
polarity (Accumulated
temperature only)
Set High/Low accumulated polarity.
3-axis Acceleration / Temperature Sensor of the wireless sensor setting: optional
(GL100-WL+GS-3AT)
Perform the settings for the 3-axis acceleration / temperature sensor input of wireless sensors.
When the wireless sensor and 3-axis acceleration / temperature sensor are connected, the setting screen is
displayed.
(1)-17 Input setting
This is used to select the input conditions.
Setting Description
Off The input signal is not measured. The waveform and digital display also are not performed.
1ch TEMP The temperature is measured with the xed temperature sensor inside the sensor part.
2ch to 4ch ACC. X (Y, Z) Measure XYZ direction of the acceleration inside the sensor part.
* 2ch: X-axis, 3ch: Y-axis, 4ch: Z-axis direction
5ch to 8ch No AMP Because the other wireless sensor cannot be installed, the “No AMP” is displayed.
(1)-18 Sensor setting
This is used to select the data processing method of the acceleration sensor.
Setting Description
1ch None
2ch to 4ch Peak The maximum value of the data is displayed.
Ave. The mean value is displayed.
RMS The root mean square value is displayed.
To Next Page
Loading...
