3-35
CHAPTER 3 Settings and Measurement
(1)-26 Other setting
Annotation text, Inter-CH calculation, span, line width, trace, and zero point, etc. can be set.
Refer to “(1)-6 Misc.” in “3.4 Setting Menus”.
(1)-27 Logic / Pulse setting
This is used to perform the setting related to the digital input to the GL240.
Refer to “(1)-7 Logic/Pulse” in “3.4 Setting Menus”.
However, for Group settings, LOGIC5 to LOGIC8 and PULSE5 to PULSE8 are displayed.
When the pulse is measured by the GL100-WL, the pulse measurement is executed by GL100-WL.
The fastest sampling speed of the GL100-WL is 500 ms.
When the sampling speed of the GL240 is faster than 500 ms, there is a possibility that the error between
the value captured in 500 ms by the GL100-WL and the pulse captured by the GL240 may occur, in order to
execute the calculation processing within the sampling interval of GL240.
4ch Thermistor Terminal of the wireless sensor setting: optional
(GL100-WL+GS-4TSR)
Perform the settings for the 4ch thermistor terminal input of wireless sensors.
When the wireless sensor and 4ch thermistor terminal are connected, the setting screen is displayed.
(1)-28 Input setting
This is used to select the input conditions.
Setting Description
1ch to 4ch Off The input signal is not measured. The waveform and digital display also are not performed.
TEMP Used to measure the temperature.
5ch to 8ch No AMP Because the other wireless sensor cannot be installed, the “No AMP” is displayed.
To Next Page
Loading...
