3-39
CHAPTER 3 Settings and Measurement
CO2 sensor of the wireless sensor setting: optional
(GL100-WL+GS-CO2)
Perform the settings for the CO2 sensor input of wireless sensors.
When the wireless sensor and CO2 sensor are connected, the setting screen is displayed.
(1)-38 Input setting
This is used to select the input conditions.
Setting Description
Off The input signal is not measured. The waveform and digital display also are not performed.
1ch CO2 Used to measure the CO2.
2ch to 4ch No AMP Used to measure the ultraviolet.
5ch to 8ch No AMP When connecting the two GS series and terminal / addapter using a branch adapter for GS, the
following combination is displayed.
Combination CH1 to 4 CH5 to 8
TH+LXUV TH LXUV
TH+CO2 TH CO2
LXUV+CO2 LXUV CO2
Symbols in the table are as follows:
TH: Temperature and humidity sensor
LXUV: Illumination / ultraviolet sensor
CO2: CO2 sensor
(1)-39 Range setting
The CO2 range is xed.
Setting Description
CO2 5000ppm xed range
(1)-40 EU setting
This is used to unit-convert the measurement signal.
Refer to “(1)-5 EU (Scaling settings)” in “3.4 Setting Menus”.
To Next Page
Loading...
