3-38
CHAPTER 3 Settings and Measurement
(1)-36 EU setting
The unit of Illumination/ultraviolet is converted.
Refer to “(1)-5 EU (Scaling settings)” in “3.4 Setting Menus”.
There is no “EU Function” for accumulated illuminance and accumulated ultraviolet.
Even if the scaling setting is applied to the original measured value of CH, the accumulated illuminance is
not reected in the accumulated illuminance CH.
(1)-37 Other setting
The following settings can be performed.
Setting Description
Annotation text string Set the annotation (comment) displayed in the CH.
Program Inter-CH
calculation
Set the contents of Program Inter-CH calculation.
Four arithmetic operations (addition (+), subtraction (-), multiplication (x), division (÷)) can be used for
the Program Inter-CH calculation.
* For details, refer to “<Inter-CH Op Settings>” in “(1)-6 Misc.” in “3.4 Setting Menus”.
Span setting Set the upper and lower limits of the span which the waveform is displayed.
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Line Thickness Setting 1 to 8 dots
Trace This is used to set the waveform display.
Auto zero adjustment The current input value is calculated as a zero point.
Zero adjustment reset Reset the zero point.
Zero point voltage value Display the zero point.
To Next Page
Loading...
