GRASS VALLEY JUPITER CM-4400 - VERSION 7.9.0 - 10-2010 - Power Cycling the CM; Using the Console Port

JUPITER CM-4400 Control Module Installation and Operating Manual 105
Restart Procedures
2. Select the Reset button on the front of the CM-4400 (Figure68).
Figure 68. The Reset button on the front of the CM-4400
The above steps are the preferred method for pressing the Reset button.
However, there is a hole on the front cover in which you can stick a narrow
object (for example, pen, pencil, or small screwdriver) to reset the CM-4400
without removing the front cover.
Power Cycling the CM-4400
If the two methods described above do not restart the CM, you can unplug
the power cord; you will then need to plug the power cord back in to the
power socket.
Using the Console Port
All boards can be reset by momentarily shorting pin 7 to pin 5 on the
Console port. This is the least preferred method.
Note The Console connection is provided for test purposes.
Figure 69. The Console Port on the front of the CM
071826105_FrontCoverremoved
Reset Button
071826105_FrontCoverremoved
Console Port