JUPITER CM-4400 Control Module Installation and Operating Manual 207
Video Reference Table
Video Reference Table
The Video Reference table is used only for configuring a CM-4000, or 4400,
System Controller that is running the AccuSwitch software.
Figure 152. Video Reference Table
Follow these steps to configure the Video Reference table:
1. Choose the preferred video standard from the Sync Standard drop-
down list.
• Choices are: NTSC, PAL, 1080i 60Hz, 1080i 50Hz, and 1080i
59.94Hz.
2. Select the switch point in the video frame from the Horizontal drop-
down list.
Choices are:
• NTSC choices are 9.5, 10, 10.5, 11, 1
1.5, 12, 12.5, and 13. The [default
and] SMPTE recommended setting is 10.5.
• PAL choices are 5.5, 6, 6.5, 7, 7.5, 8, and 8.5. The [default and
SMPTE] recommended setting is 6.5.
To Next Page
Loading...